Wireless motion sensor LED Smart 12-24V DC, rechargeable plastic/black (PU 4)

GPRS RF occupancy sensor for LED lighting, which switches on the LED light when human motion is detected.

Detection angle: 90°
Detection range: up to 2 m

The light will automatically switch off after 30 seconds if no further movement is detected, and will remain on as long as there is movement in the sensor's area.
Functions as a radio transmitter that sends a signal to the Smart RF receiver (sold separately), which can be installed up to 8 m away.

Flexible coupling:
– one sender can be associated with up to 10 recipients.
– one receiver can be associated with up to 10 transmitters.
– suitable for multi-point controlled lighting solutions.

Quick pairing using the built-in buttons; to reset the pairing, the button must be held down for 10 seconds.
A learning button allows the transmitter to be connected to the receiver without accessing the receiver - particularly useful for solutions that are already installed or difficult to access.

Power: 500 mAh lithium battery, rechargeable via USB-C (5 V DC charger).
Charging time: approximately 3 hours (with a 5 V / 2 A charger).

I'm not sure what "kestvus" means, but it sounds like a Finnish word.
– up to 700 on/off cycles on a single charge
- up to 18 months standby time when the emitter is switched off using the built-in ON/OFF switch.

Lifespan: approximately 500 full charge cycles.

Material: plastic
Finish: black

Compatibility: with Smart converters and 12 V DC and 24 V DC LED luminaires.
Easy to install: a metal sticker with magnets is included, allowing the transmitter to be easily attached and removed for charging, relocation or remote control.